Mahr | Roughness Metrology

ISO 21920 in practice

Marketing Team
ISO 21920 series of standards

Around two years ago, the ISO 21920 series of standards was published, which summarized and updated the previous ISO standards on "Surface Texture: Profile". Mahr provided one of the project managers, Heinz-Joachim Kedziora, Head of Surface Metrology Development.

Because some of the previous standards no longer corresponded to the current state of the art, it was not always possible to clearly describe the surface quality of the finished component – "for example, with new production processes such as additive manufacturing", as Kedziora explains: "They pose different challenges for measurement than the usual, ablative processes. That's why a new profile standard was needed after around 40 years." The result: ISO 21920 has replaced previous standards such as ISO 3274, 4287, 4288, 13565 and 1302. The series of standards consists of three parts. The first part deals with the drawing entries and defines the rules for specifying the profiled surface properties. The second part focuses on the parameters and defines the terminology as well as the terms and parameters for determining the surface quality using the stylus method. Finally, Part 3 focuses on the measurement conditions by defining a complete specification operator for the surface finish using the profile method.

Changes in practice
"Overall, all teams have placed great emphasis on continuity during the standardization process. Weak points of the old standard, imprecise definitions or parameters that are no longer practicable have been eliminated," says project manager Kedziora, who was initially responsible for the first and later also for the third part of the internationally valid series of standards during the standardization process. As he emphasizes, nothing was changed where the old standard provided reasonable results. However, where the old standard was unclear, the new regulation is now clearer. As an example, he cites filter settings that were previously dependent on the workpiece. Preliminary measurements would have been necessary, but nobody actually carried them out. "Now it's no longer the workpiece that determines the filter setting, but the corresponding drawing. In addition, the new profile standards offer extended possibilities for functionally relevant product specifications."

Info
To top